Disconnect problem: Mark incoming connections immediately local

[silc.git] / doc / draft-riikonen-silc-spec-01.nroff

diff --git a/doc/draft-riikonen-silc-spec-01.nroff b/doc/draft-riikonen-silc-spec-01.nroff
index c74e7cbbcdf151aa34f12fdfcb0ccc68545d4871..326c79cc0c1347052472068f50288d88d74401c1 100644 (file)
--- a/doc/draft-riikonen-silc-spec-01.nroff
+++ b/doc/draft-riikonen-silc-spec-01.nroff
@@ -1791,10 +1791,15 @@ without executing SKE protocol.  In this case, the new key is created by
 hashing the old key with hash function selected earlier in the SKE
 protocol.  If the digest length of the hash function is too short for the
 key, then the key is distributed as described in section Processing the
-Key Material in [SILC3].  After both parties has regenerated the session
-key, both send SILC_PACKET_REKEY_DONE packet to each other.  These packets
-are still secured with the old key.  After these packets, the following
-packets must be protected with the new key.
+Key Material in [SILC3].
+
+After both parties has regenerated the session key, both send
+SILC_PACKET_REKEY_DONE packet to each other.  These packets are still
+secured with the old key.  After these packets, the following packets
+must be protected with the new key.  After sending the REKEY_DONE packet
+all subsequent sent packets must be encrypted with the new key.  After
+receiving the REKEY_DONE packet all subsequent packets must be
+decrypted with the new key.
 
 
 .ti 0
@@ -2380,13 +2385,16 @@ List of all defined commands in SILC follows.
 
    10   SILC_COMMAND_INFO
 
-        Max Arguments:  1
-            Arguments:  (1) [<server>]
+        Max Arguments:  2
+            Arguments:  (1) [<server>]  (2) [<Server ID>]
 
         This command is used to fetch various information about a server.
         If <server> argument is specified the command must be sent to
         the requested server.
 
+        If the <Server ID> is specified the server information if fetched
+        by the provided Server ID.
+
         Reply messages to the command:
 
         Max Arguments:  4
@@ -2404,6 +2412,8 @@ List of all defined commands in SILC follows.
             SILC_STATUS_ERR_NOT_ENOUGH_PARAMS
             SILC_STATUS_ERR_TOO_MANY_PARAMS
             SILC_STATUS_ERR_NO_SUCH_SERVER
+            SILC_STATUS_ERR_NO_SUCH_SERVER_ID
+            SILC_STATUS_ERR_NO_SERVER_ID
 
 
    11   SILC_COMMAND_CONNECT
@@ -2656,6 +2666,7 @@ List of all defined commands in SILC follows.
               privileges by SILC_COMMAND_SILCOPER command.  Client
               may unset the mode itself.
 
+
         Reply messages to the command:
 
         Max Arguments:  2